or drop it here, or paste it with Ctrl+V
Best photos: shot from the pilot seat at panel height, phone level, flash off, yoke pushed in or turned out of the way.
Drag the four handles to the corners of the main flat panel plate. Keep it to the plate that will be cut; leave the sub-panel and glareshield out.
Cleaning runs in the page: levels, glare knock-down, light sharpening. Detection sends the flattened photo to Claude, which marks every instrument it can see and estimates scale from the 3 1/8 in gauges. You confirm both in the next steps.
Click two points across something with a known size. Certified instrument holes are the easy reference.
Or enter the full plate width if you know it:
- Click the middle of each round gauge to mark it.
- Press and drag across a radio or display to mark it.
- Click a mark and choose Remove or Keep in the small menu beside it. Its name and the rest are under the photo.
The tools are under the photo. Hold the mouse over any button to see what it does. Made a mistake? Undo is at the top.
Tap a catalog item to add it, then drag it into place. Round units snap to marked holes; stack units snap into a column.
Size not set. Sizes in the picture are estimated from an assumed 40 in panel. Set the size in step 3 so the new units show at their real size.
The layout is a visual plan for the customer and the shop, not a cut drawing. Take every cutout size and position from the unit's installation manual and measure on the aircraft.
Parts list
| Unit | Mount | Aircraft | Qty | Shop price | Ext |
|---|